[. . . ] Trimming with beard trimming comb Note: Make sure your facial hair is clean and dry. Make sure that the arms of the comb have been properly slid into the grooves on both sides. 3 Press the length setting selector (1) and then move the beard trimming comb up or down (2) to set the desired length setting (Fig. Length settings With the beard trimming comb attached, the appliance can cut hair to 8 different lengths: Hair lengths in mm Hair lengths in inches 1. [. . . ] Warning Check if the voltage indicated on the adapter and on the appliance corresponds to the local mains voltage before you connect the appliance. Do not cut off the adapter to replace it with another plug, as this causes a hazardous situation. This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. Use, charge and store the appliance at a temperature between 15°C and 35°C. If the adapter is damaged, always have it replaced with one of the original type in order to avoid a hazard. Do not use the appliance if the cutting element, the hair clipping comb or the beard trimming comb is damaged or broken, as this may cause injury. This appliance is only intended for clipping human scalp hair and facial hair. 5 Place the hair clipping comb on the scalp and move the appliance through the hair slowly. tips Start clipping at the highest length setting of the hair clipping comb and reduce the length setting gradually. Write down the length settings you have used to create a certain hairstyle as a reminder for future clipping sessions. 1 Make sure the appliance is switched off and disconnected from the mains. 2 To remove the comb, press the length setting selector (1), move the comb upwards and then pull it off the appliance (2). 8) 3 Push the middle part of the cutting unit upwards with your thumb until it opens (Fig. 5 Clean the inside of the appliance with the cleaning brush supplied (Fig. 6 Clean the hair clipping comb and the beard trimming comb with the cleaning brush supplied. Replacement The cutting unit, the adapter and the hair clipping comb are replaceable. Replacing the cutting unit Replace the cutting unit if it is damaged or worn. 1 Push the middle part of the cutting unit upwards with your thumb until it opens and then pull it off the appliance (Fig. 2 Place the lug of the new cutting unit in the slot and push the cutting unit onto the appliance (`click') (Fig. Environment Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an official collection point for recycling. Always remove the batteries before you discard and hand in the appliance at an official collection point. [. . . ] Always remove the batteries before you discard and hand in the appliance at an official collection point. dispose of the batteries at an official collection point for batteries. If you have trouble removing the batteries, you can also take the appliance to a Philips service centre. The staff of this centre will remove the batteries for you and will dispose of them in an environmentally safe way (Fig. [. . . ]